3D printers are great at creating complex geometry out of plastic, and that geometry can often pull off some impressive tricks. [DaveMakesStuff] found a way to generate geometry that draws …read more (https://hackaday.com/2022/09/16/hand-cranked-doodler-made-using-a-3d-printer/)

AntRunner Is The Satellite Antenna Mount You Need To Take With You
https://hackaday.com/2022/09/17/antrunner-is-the-satellite-antenna-mount-you-need-to-take-with-you/

It stands to reason, that should you wish to communicate with a satellite, whatever antenna you use should point at that satellite. Some of us have done this by hand, …read more (https://hackaday.com/2022/09/17/antrunner-is-the-satellite-antenna-mount-you-need-to-take-with-you/)

3D Printer Upcycles Computer Case To DAS
https://hackaday.com/2022/09/17/3d-printer-upcycles-computer-case-to-das/

Storage technologies are a bit of an alphabet soup, with NAS, SAN, and DAS systems being offered. That’s Network Attached Storage, Storage Area Network, and Direct Attached Storage. The DAS …read more (https://hackaday.com/2022/09/17/3d-printer-upcycles-computer-case-to-das/)

Why Can’t We Have Pretty Things?
https://hackaday.com/2022/09/17/why-cant-we-have-pretty-things/

I was reading [Al Williams]’ great rant on why sometimes the public adoption of tech moves so slowly, as exemplified by the Japanese Minister of Tech requesting the end of …read more (https://hackaday.com/2022/09/17/why-cant-we-have-pretty-things/)

3D Printable Bearings That Actually Work, No CAD Tweaking Required
https://hackaday.com/2022/09/17/3d-printable-bearings-that-actually-work-no-cad-tweaking-required/

3D printing bearings with an FDM printer can be an iffy endeavor, but it doesn’t have to be that way. [Matvey Kukuy]’s Ultimate 608 Bearing with Calibration Kit is everything …read more (https://hackaday.com/2022/09/17/3d-printable-bearings-that-actually-work-no-cad-tweaking-required/)

3D Printed Strain-Wave Gearbox Turns Up the Torque
https://hackaday.com/2022/09/17/3d-printed-strain-wave-gearbox-turns-up-the-torque/

3D printers are good for a lot of things, but making parts for power transmission doesn’t seem to be one of them. Oh sure, some light-duty gears and timing belt …read more (https://hackaday.com/2022/09/17/3d-printed-strain-wave-gearbox-turns-up-the-torque/)

DIY Haptic-Enabled VR Gun Hits All The Targets
https://hackaday.com/2022/09/17/diy-haptic-enabled-vr-gun-hits-all-the-targets/

This VR Haptic Gun by [Robert Enriquez] is the result of hacking together different off-the-shelf products and tying it all together with an ESP32 development board. The result? A gun …read more (https://hackaday.com/2022/09/17/diy-haptic-enabled-vr-gun-hits-all-the-targets/)

The CPSC Says Plug To Socket, Not Plug To Plug, Please
https://hackaday.com/2022/09/17/the-cpsc-says-plug-to-socket-not-plug-to-plug-please/