farmer performs mental reset on dummy

The balloon has gone up.

The S*%T has hit the fan....

You go on a procurement run in to town... Do you have a battery powered angle grinder?

A few weeks ago I got some galvanized pallet racking for behind my workshop. This week I've been pouring concrete footers for the racks. I've used the laser level to set the elevation of the tops of the cardboard tubes and been careful to float the concrete to the right elevation. We put up one of the racks tonight and found something "fun". One of the verticals doesn't start at the same hole offset as the others it's off by 1/2". To be honest my concrete is low by 1/4"... and combined with that particular vertical makes the elevation of that rack 3/4" low. I think I'll flip it around backwards to make the error is offset go the other way... but isn't this fun..... Worst case, I'll shim the feet before I anchor them to the concrete.

Now I know why this racking was cheap.. it's 2nd run quality.

Holy smokes... teh new 56a "double" lfp cells have 684ah capacity per cell.... 2.5kwh per cell.... that would be 37.6kWh per 48v battery. https://www.youtube.com/watch?v=IViC6YHfLN8

Raising the grade inside the footprint of the greenhouse. Final grade will be 2in below the bottom holes in posts. Yesterday we relocated the water and electrical lines from the left right center to the front corner. Later ill switch that spigot to a hydrant.

Can I just use a stainless steel bolt hanging on the bottom of a fishing float with a tiny hole drilled through the cap and a tennis ball hanging on the outside so when it's at the top my tank is empty and when it's down by the bottom my tank is full? I've done this before with 50 lb test line and never had to replace them.

How to Build a Ram Pump DIY Tutorial

The Ram Pump Design Manual Calcs Pressure Elevation Measurements Sizing Operation.

I had an epiphany today. We are grading around the greenhouse and I gotta remove dirt. So the question is how to know how many inches of dirt I have left to remove with my laser level and the "beep beep ding ding" receiver? It only reads UP or DOWN within 1inch of level.

So it occured to me that I have a telscoping grade rod. If I turn it upside down and clip the receiver to the fattest portion of it, I can push it down telescoping the smaller portion into the larger part. Read the scale on it to know the difference.

Example: extend the smallest section of the grade rod fully and facing down. Attach the beeper to the fatter portion. To measure go where you need to measure the earth, push down on the rod and make it compress. When the beep goes solid, read the number of inches it compressed.

Ram pump in switzerland